Car U Joint_What Is A U Joint-Jiangsu Sitong Cardan Shaft Co.,Ltd
Welcome To Jiangsu Sitong! We are Professional Cardan shaft manufacturer.
  +86-18852632222 丨    lynn@cardanshaft.com.cn

Car U Joint_What Is A U Joint

Views:12     Author:Cardan Shaft Manufacturer     Publish Time: 2020-08-27      Origin:Sitong Cardan Shaft Co.,Ltd

  an article about car u joint。

  The U Joint, which is also known as the Cardan or Hooke joint, converts the torque generated by your cars engine and transfers them into the differentials and drive wheels of your vehicle. Basically, should this part fail, your ride wont be going anywhere until you get it replaced.

  A descriptive term for a u-joint that links the front of the driveshaft to a vehicles transmission output shaft. Bearing Cap (or Bearing Cup) These fit on the ends of each of the + shaped cross pieces in a U-joint assembly, and are secured with snap rings around …

  A u-joint, or universal joint, is a component that connects the driveshaft to the differential, and sometimes connects the driveshaft to the transmission or two driveshafts to each other. It’s a cross shaped piece with a bearing at each end, that allows for lateral and side to side movement of the driveshaft. What does it do?

  A universal joint consists of a cross-shaped spider with needle roller bearings held on its four arms by caps and circlips. The yoked ends of two shafts have lugs which engage with the spider arms and can pivot on the roller bearings . In most modern cars the joints are sealed for life and cannot be lubricated.

  car u joint_what is a u joint

car u joint

  Universal joints allow drive shafts to move up and down with the suspension while the shaft is moving so power can be transmitted when the drive shaft isn’t in a straight line between the...

  MOOG Super Strength U-Joint 281. Notes: Greaseable, 4-1/2" yoke outside diameter. 2-joint driveshaft, at transmission, at rear axle. 3 or 4-joint driveshaft, at transmission, at center bearing, at rear axle.

  These steel U-joints meet MIL-U-20625A Class A and have hardened yoke ears for added strength and durability. Machinable-Bore Single U-Joints These U-joints are made of steel.

  Jun 12, 2017 · The job of the U-joint is to transfer rotational power from the engine onto the wheels of the vehicle. One end of the U-joint is connected to the engine’s output shaft, and the other end is connected to the axle of the wheels. U-joints are also used to adjust the height misalignment between the power transmission and the rear axle.

  We recommend using a caliper or micrometer to most accurately measure u-joints. Once you have recorded your measurements, click on the images below to select the appropriate style of u-joint you have. You will then be directed to The Expert to identify your u-joint kit by the dimensions you recorded. Where to Buy Spicer ® Parts GO

  This is the end of this car u joint,For further information regarding what is a u joint、bad u joint sounds、car u joint Please stick around


We have first-class production line and strict management system.

Contact Us

江苏四通机械制造有限公司
Jiangsu Sitong Cardan Shaft Co.,LTD
Tel : +86-523-84549777
Phone : +86-18852632222
E-mail : lynn@cardanshaft.com.cn
Whatsapp : +86-18852632222
Skype : sales@nskfagbearings.com
QQ : 510994342

Contact Us

Copyright 2020  Jiangsu Sitong Cardan Shaft Co.,Ltd All Rights Reserved. 网站地图 Sitemap