When people use cars, various problems often arise, such as how to remove the cardan join of the drive shaft.
When disassembling, you need to open the lock claw of the lock plate, remove the bearing cover fixing bolt, remove the lock plate and bearing cover, and finally push out the bearing sleeve and needle by hand. For some relatively tight bearings, you can use a hammer to hit the universal joint. There are many drive shafts in automobiles, especially some rear-wheel drive vehicles and four-wheel drive vehicles, and the number of drive shafts will be more.
The transmission shaft is a very critical component in a car, and the transmission shaft plays a role in transmitting power. It is recommended that car friends raise the car with a lift to check the chassis when maintaining the car. If there is oil leakage in the universal joint, it can be found in time. The front wheel of a front-wheel drive vehicle has a half shaft, and there is a sealing sleeve on the half shaft. This sealing sleeve will age after long-term use.
The aging of the half shaft seal sleeve will easily cause oil leakage on the half shaft. If the semi-shaft has oil leakage and is not repaired in time, it will cause excessive wear of the semi-shaft due to lack of lubrication. If the axle shaft is excessively worn, the axle shaft will make abnormal noises while driving. In normal maintenance, these transmission systems should be maintained. Without maintenance, these transmission systems are prone to failure, and they can only be replaced when they fail.