Length: follow customer's requirements
Surface Treatment: Painting
Min order: 1 set
Material: follow customer’s requirements
For more dimensions and drawings about industrial cardan shaft, you can click "Service" and download.
The following are dimensions and drawings of SWC-BH cardan shaft with length compensation as a model.
Our min order is 1 set. Most of our products are customized. Each order from our factory, we always produce cardan shaft after customer confirmed the drawing. So we didn't have stock. And since we are based on final customer confirmed drawings production, so before this, customer has any needs can be adjusted.
We do manual measurement and dynamic balance test of repair workshop industrial cardan joint
How to do manual measurement of repair workshop industrial transmission shaft?
The inspectors measure the length of the repair workshop industrial propeller shaft, the size of the flange, the number of holes on the flange and its diameter according to the drawing.
How to do dynamic balance test of repair workshop industrial universal shaft?
According to the customer's cardan shaft for repair workshop/min and accuracy level parameters do the dynamic balance test, if any problems with the test, we will add the balance block at both end of the cardan joint for repair workshop , and then continue to dynamic balance test to know the results of transmission shaft for repair workshop test to meet the min and precision level parameters.
If you buy our transmission shaft for repair workshop, we will provide following services:
1. For domestic customers, when we receive customer complaints about propeller shaft for repair workshop , we will send technicians to the spot, analysis the cause, and help solve the problem.
2. For customers abroad, we will ask them to send photos and vedios of the propeller shaft for repair workshop , our technicians will analysis the cause, and give the solve guidance to customers.
3. General speaking, there is no quality problem of our transmission shaft for repair workshop, we produce strictly according to the detailed drawing. The problem is always caused by wrong maintenance. Please note to add grease for the spline and cross cardan frequently. Usually once a month, for cars, once per 15 days.