Length: follow customer's requirements
Surface Treatment: Painting
Min order: 1 set
Material: follow customer’s requirements
For more dimensions and drawings about industrial cardan shaft, you can click "Service" and download.
The following are dimensions and drawings of SWC-BH cardan shaft with length compensation as a model.
Our min order is 1 set. Most of our products are customized. Each order from our factory, we always produce cardan shaft after customer confirmed the drawing. So we didn't have stock. And since we are based on final customer confirmed drawings production, so before this, customer has any needs can be adjusted.
We do manual measurement and dynamic balance test of SWC series industrial cardan shaft.
How to do manual measurement of SWC power station cardan shaft?
The inspectors measure the length of the cardan shaft for power station, the size of the flange, the number of holes on the flange and its diameter according to the drawing.
How to do dynamic balance test of SWC cardan shaft for power?
According to the customer's power station equipment cardan joint /min and accuracy level parameters do the dynamic balance test, if any problems with the test, we will add the balance block at both end of the power station equipment transmission shaft , and then continue to dynamic balance test to know the results of SWC series industrial cardan joint test to meet the min and precision level parameters.
If you buy our cardan joint for power station, we will provide following services:
1.For domestic customers, when we receive customer complaints about SWC series industrial transmission shaft, we will send technicians to the spot, analysis the cause, and help solve the problem.
2.For customers abroad, we will ask them to send photos and vedios of the SWC series industrial cardan joint, our technicians will analysis the cause, and give the solve guidance to customers.
3.General speaking, there is no quality problem of our power station equipment transmission shaft, we produce strictly according to the detailed drawing. The problem is always caused by wrong maintenance. Please note to add grease for the spline and cross cardan frequently. Usually once a month, for cars, once per 15 days.