Length:follow customer's requirements
Min order:1 set
Material:follow customer’s requirements
The dimensions and drawings of stainless steel drum gear coupling is as follows:
When the stainless steel drum gear coupling is at work, two relative angular displacement of the shaft of the internal and external gear tooth surface of periodic axial relative sliding, inevitable formation of tooth surface wear and power consumption, therefore, the coupling should be in good and sealing state work. Type coupling radial size is small, large carrying capacity, often used for shaft transmission of working condition of low speed and heavy loading, high precision and the dynamic balance of coupling can be used for high-speed transmission, such as gas turbine shaft transmission.
To control the quality of stainless steel cardan shaft,we do manual measurement and dynamic balance test.
Manual measurement of stainless steel drive shaft：
The inspectors measure the length of the stainless steel propeller shaft, the size of the flange, the number of holes on the flange and its diameter according to the drawing.
Dynamic balance test of stainless steel transmission shaft:
According to the customer's ST stainless steel drive shaft r/min and accuracy level parameters do the dynamic balance test, if any problems with the test, we will add the balance block at both end of the ST stainless steel drive shaft, and then continue to dynamic balance test to know the results of the ST stainless steel transmission shaft test to meet the min and precision level parameters.
If you buy our ST drum gear coupling, we will provide following services:
1. For domestic customers, when we receive customer complaints about ST stainless steel propeller shaft, we will send technicians to the spot, analysis the cause, and help solve the problem.
2. For customers abroad, we will ask them to send photos and vedios of the problem ST stainless steel propeller shaft, our technicians will analysis the cause, and give the solve guidance to customers.
3. General speaking, there is no quality problem of our ST stainless steel transmission shaft, we produce strictly according to the detailed drawing. The problem is always caused by wrong maintenance. Please note to add grease for the spline and cross cardan frequently. Usually once a month, for cars, once per 15 days.